Adding Additional Ports To Your Pterodactyl Nodes

Head over to your Pterodactyl panel and go to the admin side which is the button in the top right corner, a cog icon.

Click on "Nodes" along the left hand side.

In the node list, click on the blue text. Normally, you will only have one node called "S01" for Server 01, but choose which one you want to add an allocation to.

Click "Allocation" along the top bar.

In the allocation table, you will see on the right a "Assign New Allocations" header.

When using more than one dedicated system, the IP Address can be different, dependent on your network infrastructure, so ask the team before continuing if you are confused. For example, your internal networking could be 10.10.10.1 to 10.10.10.5, each dedicated system being an IP in that range.

In our case, we did 10.10.10.1 with alias "DiscordBot" to hide from non admins on port 3000. We click the green "Submit" button.

image.png

If you get the this error, Make sure you choose a port over 1024 as these are restricted to root level access only.

image.png

If you get either below error, make sure you actually filled out an IP in the IP Address box or a port in the Ports box!

If successful, you will get the below success message.

You can delete an allocation by clicking the red bin icon in the allocations table on the left.

image.png  

You can also bulk remove them by ticking them along the left, then scrolling back up to the top and clicking "Mass Actions" top right, and pressing "Delete."

image.png image.png

Now when you go to "Servers" on the left sidebar and "Create New" on the top right, you can now select which node to use and your port will appear there.

image.png 

Adding ports to existing servers

Go to the Admin Side > Servers > Click a server > Build Configuration.

image.png

In the bottom right, there is a section called "Allocation Management". Each option is self explanatory.


Revision #13
Created 26 June 2023 13:30:48 by JasmeowTheCat
Updated 8 December 2024 19:43:28 by JasmeowTheCat